exterior wall panels waterproof uk

basement waterproofing

wall conduits such as dimple boards or other membranes are fastened to the foundation wall and extend over the new drainage to guide any moisture down into the system. interior waterproofing. interior basement waterproofing using coatings is effective where condensation is the main source of wetness. it is also effective if the problem has .

rigid panel

on the exterior side of the studs in a framed wall assembly, or on the exterior side of a mass wall assembly. inside unfinished interior walls, either as pre-cut batts, or as panels cut to fit inside walls and secured in place.

tadelakt

tadelakt moroccan arabic: تدلاكت ‎, tadla:kt is a waterproof plaster surface used in moroccan architecture to make baths, sinks, water vessels, interior and exterior walls, ceilings, roofs, and floors. it is made from lime plaster, which is rammed, polished, and treated with soap to make it waterproof and water-repellant. tadelakt is labour-intensive to install, but durable.

damp proofing

in a masonry cavity wall, there is usually a dpc in both the outer and inner wall. citation needed in the outer wall it is normally 150 millimetres 5.9 in to 200 mm 7.9 in above ground level the height of 2-3 brick courses . this allows rain to form puddles and splash up off the ground,.

foam glass

foam glass is fireproof, waterproof, non-toxic, corrosion-resistant, anti-mite, non-aging, non-radioactive, and insulating. anti-magnetic wave, anti-static, high mechanical strength, with good adhesion to various types of mud. it is a stable building exterior wall and roof insulation, sound insulation, and waterproof material.

glossary of british bricklaying

honeycomb wall: a wall, usually stretcher bond, in which the vertical joints are opened up to the size of a quarter bat to allow air to circulate. commonly used in sleeper walls. indent: a hole left in a wall in order to accommodate an adjoining wall at a future date. these are often left to permit temporary access to the work area.

oriented strand board

the most common uses are as sheathing in walls, flooring, and roof decking. for exterior wall applications, panels are available with a radiant-barrier layer pre-laminated to one side; this eases installation and increases energy performance of the building envelope .

shōji

fully traditional buildings may have only one large room, under a roof supported by a post-and-lintel frame, with few or no permanent interior or exterior walls; the space is flexibly subdivided as needed by the removable sliding wall panels.